May 17, 20206 yr Hey Does anyone had success with Ezca camera in v5 ? If I "click" on the caméra in main ezca panel everything good but as soon as I use my yoke command to switch view it switch to view that doesnt even exist, change my zoom setting,... Same when I switch catégories it goes outside view and then switch between outside and tower but never go back on the inside view Any idea ? SOLVED HERE'S THE SOLUTION IN CASE I had to delete every view key assignement in p3d AND ezca and then remap them Thanks Edited May 17, 20206 yr by dyl55
May 17, 20206 yr Commercial Member Hi! Also note that for the EZCA v3.1 VC mouse view worked correctly, you must disable the "Enable advanced mouse control" option in Prepar3Dv5. Nick Bebyakin / Handmade cameraset - Ezdok v2 and Ezdok v3 EZdok Software. Support remains on the http://www.ezdok-camera.com/ [email protected] / 20Gb / RTX 2060-OC-6Gb / Win10x64 / MSFS2020
Archived
This topic is now archived and is closed to further replies.