Hello

I am attempting to install LINDA for use with P3Dv5 with the NGXu aircraft.

Is there any specific module for the NGXu in V5 or is v1.4 current?

Presently, I have P3D v4 and v5 installed, I am able to use the modules in V4 but not V5

I have the current version of LINDA and FSUIPC installed and when LINDA starts all checks out OK

 

 

The setup for P3Dv5 differs significantly from previous versions. Please see Download post and release notes.

FSUIPC6 (latest 6.0.10) and LINDA 3.2.5 should be installed in /documents/prepa3d v5 add-ons/fsuipc6.

The latest version of the NGXu module will work with P3Dv5 and needs to be installed in the above /fsuipc6 directory.

If that fails, please read and follow the Fault Diagnosis Procedure (under LINDA Support) and email me the specified log files.

Hi

FSUIPC6 (latest 6.0.10) and LINDA 3.2.5 installed in /documents/prepa3d v5 add-ons/fsuipc6

When I call up the main LINDA panel "Everthing is OK" in all areas

The aircraft module is selected and synced to the sim

The problem I have I am unable to get any switches on my Hotas Warthog throttle unit to operate when I assign them to the specific  commands (eg NGX YawDamper)

Please will you advise and assist further..thanks

Clive

I am sending the following files to the email address Linda @ awginfosys.net

Fsuipc6

Linda2

Config-hid

 

Edited August 4, 20205 yr by ScotFlieger

Good News.  I have it working..what did I do different?

I re-installed FSUIPC (selecting V4 & V5 shared installation).  I  deselected the XML method. (FSUIPC installation is inside P3D v4 Modules folder) I then re-installed the aircraft module using the Import option with LINDA maintenance.

Trying to understand what I have done I think I have resolved the problem by installing as a dual installation instead of two seperate installations in which P3D v5 uses and XML method....I think..ha..ha

Clive