It would seem somebody boobed.  The Throttle Quadrant that is a part of the Flight Yoke is missing one of the Axis. I want Spoiler on Joystick R-Axis X, Throttle 1 on Joystick R-Axis Y and Throttle 2 on Joystick R-Axis Z.  Went to map it and found X is the middle axis, Y the right axis and there is no left axis or a label for R-Axis Z.

I have yet to even find the files associated with this new Flight Sim to see if this is a simple fix.  Anybody got any ideas?

 

Martin

 

Perhaps take a look for [Joystick L-AxisZ] for the left most, that's how it's designated on the combo Cessna yoke/quadrant, so the following...

[Joystick L-AxisX] - Ailerons Axis

[Joystick L-AxisY] - Rudder Axis

[Joystick L-AxisZ] - Spoiler Axis

[Joystick R-AxisX] - Throttle 1 Axis

[Joystick R-AxisY] - Throttle 2 Axis

Just go in and do it manually. Go to the controllers section, select your controller, filter on the left set to all, then find inputs for spoiler axis (under flight controls), throttle axis 1 and throttle axis 2 under power management. For each of these inputs, select "search by input," then move the joystick lever that you want to use for the axis. Click on validate and move on to the next one. After you have them all, click apply and save. No need to know what each joystick axis is called.

Make sure Filter (on the left) is set to “All”

Thank you all, realized my mistake when I looked at the calibration screen.