I have things working pretty well w/o VR, but while in VR (though it looks pretty incredible), I'm having a few issues, namely:

1. Lots of flickering (scenery, menus, tooltips, etc)

2. Normally, I'm able to zoom with my mouse wheel, but that's not working in VR. Perhaps I need to bind zoom with something else?

3. Sitting in the 787 cockpit, it's almost impossible to read text on the glass displays, FMS, radio, etc. Even switches that are close up are blurry. While in the hanger, I'm able to see the menu OK, especially when looking directly ahead (periphery is blurry). I've set my IPD on the headset itself.

4. I CTD first when clicking on the battery switches in the 787, and after restarting, I CTD again when clicking on the APU gen.

I'm using a Reverb H2 with 3080, 10850K, 32GB ram....graphics setting are mostly med and high, with some ultra. I'm happy to change the settings, but not sure where to start.

Any ideas on any of these? Thanks!

Try to set two options in settings for WMR to performance instead of quality this will reduce jerkiness

Thanks! That helped a little bit but there's still a lot of flickering 😞 

I kept getting CTDs when starting up the 787, so I switched to the 747 - same thing. If I start on the runway, I can get things going, but from cold and dark, not so much.

Also, I'm pretty sure the only zoom available is with the right mouse button....but it's still pretty fuzzy.

Well, I feel like an word not allowed...

1. I didn't realize that VR had it's own graphics profile - I was changing things before going into VR, but once in VR, it was using a different profile. Now that I've changed the VR profile, things are looking better.

2. The CTD may actually be the fact that the mouse in VR still acts on the window outside of VR, and you can close the sim if you move the mouse to the upper right and click. I'm going to see if I can go into full screen rather than windowed mode.