August 16, 20214 yr First I don't think this is a problem with Honeycomb. I have the throttle since it came out. No problems till after the last update. In the Controls Options under the Bravo Throttle Quadrant. I setup a configuration for a Complex Single, Complex Twin, 2 Engine Jet, 4 Engine Jet and TBM 930. These were setup and working before 1.18.15.0. After the update the configurations don't work. I reset them works fine till I close the sim and load it again. Then they are messed up again. I read somewhere the others were having similar problems. The axis are the problem. So is there a known problem? Is there a work around? Is there now a certain way to select a aircraft then have to go to controls and select the correct configuration. I don't remember having to do that before the update. Thanks to all who replay. Bill McCracken
August 17, 20214 yr So did you figure it out? Your 2nd post is a bit puzzling. I was about to post that I have probably 10 or so profiles in my Bravo configs and none have been a problem since SU5, however I have done a couple of complete re-installs since, due to a multitude of problems but all seem to be resolved now and I'm enjoying the sim better than ever now.
August 17, 20214 yr 5 minutes ago, Flypops said: So did you figure it out? Your 2nd post is a bit puzzling. I was about to post that I have probably 10 or so profiles in my Bravo configs and none have been a problem since SU5, however I have done a couple of complete re-installs since, due to a multitude of problems but all seem to be resolved now and I'm enjoying the sim better than ever now. probably user error on his part lol
Archived
This topic is now archived and is closed to further replies.