Main Panel black, "N" not opening it

[Erik Schlijper 0]

Goodday,

Today I installed the Maddog and the FS2Crew with it. I enabled Fs2Crew in the Maddog Load Manag. I set Autofeather On/Off to my N key to open the FS2Crew panel.
It is not opening when i press the N key, and when I open it up using the Vehicle\Instrument Panel dropdown the panel is black and can't interact, same for the secondary panel.

Sincerely,

Erik Schlijper

[byork 2,260]

Hi Erik,

Black panels mean the gauges didn't load.

Are you using the 64 bit version of Prepar 3D (P3D v4 and v5)?

Looking at your order, you bought the version of FS2Crew for the non-64 bit version of P3D.

So the the FS2Crew gauges won't load in that case.

I'm assuming this is your problem.

If so, send me a support ticket via www.fs2crew.com so we can get you the correct version.

 

[Erik Schlijper 0]

Hello Bryan,

I am using the 64Bit version. I purchased it from simmarket.
Could it be the case that it installed in my Prepar3D v5 Addons folder? Shouldn't it be in P3Dv5 root folder?

Sincerely

Erik

[byork 2,260]

9 hours ago, Erik Schlijper said:

Hello Bryan,

I am using the 64Bit version. I purchased it from simmarket.
Could it be the case that it installed in my Prepar3D v5 Addons folder? Shouldn't it be in P3Dv5 root folder?

Sincerely

Erik

Hi Erik,

That's the problem.

When you install FS2Crew, the installer will auto point to the main P3D folder.

FS2Crew needs to go to the "main" P3D folder.

Don't manually point the installer anywhere else.

Cheers,