Hi,

I'm using Pilot2atc as my "main" ATC program,but I'm using second one which is built in World traffic 3.5 ATC. Reason for that is that P2a doesn't recognize WT3 traffic, so I'm using WT3 ATC just to alert me if there is traffic on runway etc. My problem is that frequencies for the same controller are different in p2atc and in wt3 atc.

Example: Gatwick tower frequency according to Navigraph is 124.230. In wt3 atc is correct frequency number ,but in p2atc is 124.225. So when I dial 124.230 in aircraft's radio it automaticly changes to 124.225 so I can't hear wt3 atc. Is there any setting in p2atc so I can change frequency to 124.230?

But best solution would be if there was a plugin that connects p2atc and wt3 atc,because both programs are excellent 😊

Thanks

Edited December 23, 20214 yr by jsid87

P2A, along with many SIM and real world aircraft don't support the 8.33kHz spacing, so P2A Navigraph data converts these to the nearest 25 kHz spacing.   P2A will support both at some point in the future.

WT3 seems to be the only traffic engine that hasn't made their AI Traffic available via the standard X-Plane 11.5+ mechanism that shows up to 63 aircraft.  Once that happens, you'll be able to see their traffic in P2A.

Dave

 

Thanks for replying.

I tried Traffic global it's working great with P2A for traffic tracking but I didn't like it because traffic takes wind data from current position of aircraft not winds from arriving airport. So that mean planes usually land in the opposite direction...that really kills realism.

In X life there are a lot of missing airports.

Then I am left with world traffic,it ticks all the boxes(i can chose active runways, it generates a lot of traffic....)except poor integration with P2A. 

I don't know any other traffic plugin for XP11.