HI,

 

I use Littlenav Map to make flight plans from scratch. 100% IFR flights because I fly on DeltaVA ACARS. I often first pick the departure and destination airports, pick their departure procedure and arrival procedures, calculate a route using jet airways, export to FSX-SE and save the LNMP file. I find it annoying when I need to look at the arrival I picked again including the runway to enter into the FMS in the simulator I find the list of arrival procedures just disappears. I have to go back through it all and figure out what I picked again to make sure the FMS and Littlenav Map flight plan are the same.

My question is how do I keep the list of arrivals from disappearing after minimizing and maximizing the Littlenav Map window? 

Doyle

On 3/1/2022 at 4:04 PM, me1900 said:

I find it annoying when I need to look at the arrival I picked again including the runway to enter into the FMS in the simulator I find the list of arrival procedures just disappears.

Maybe I don't understand but why look at the procedure search dock window when you can see all the used procedures in the header of the flight plan window?

Unfortunately I cannot change this behavior of the disappearing dock windows. Not my code (Qt). You have to dock them into the main window or into a dock stack to keep them on.
Here is a chapter about dock windows: https://www.littlenavmap.org/manuals/littlenavmap/release/2.6/en/DOCKWINDOWS.html

Alex

Hi Alex, thank you so much for LNM!  I had to reinstall Win 10 and for some reason I have to right click the map to Show Procedures, whereas previously I could select an airport, click on the Procedure tab, it would put a nice circle over the Procedures icon on the map, I could click it and the Procedures would display.  Now, I always have to go back to the map, right click to show.  Is there a method to have it behave as it did w/ my previous install?

Thanks!

Noel

2 hours ago, Noel said:

Hi Alex, thank you so much for LNM!  I had to reinstall Win 10 and for some reason I have to right click the map to Show Procedures, whereas previously I could select an airport, click on the Procedure tab, it would put a nice circle over the Procedures icon on the map, I could click it and the Procedures would display.  Now, I always have to go back to the map, right click to show.  Is there a method to have it behave as it did w/ my previous install?

Hi Noel,

options on page "Map": Select "Show procedures on airport click" might help.

Alex

Thank you Alex!  Donation coming your way ;o)

12 hours ago, Noel said:

Donation coming your way ;o)

Just arrived.🙂
Thanks a lot, Noel!

Alex

My goodness--sure!  Thanks!