AIRCRAFT - B787 in MSFS

SYSTEM - Overhead, External power

SETUP:

I have created the profile, B787 and have created my mapping based off of BVars I found in Dev mode. The profile is active and my LVars show up in MSFS Dev Mode. I have (3) LVars: (L:AOA_B787_EXTPWR_1, number), (L:AOA_B787_EXTPWR_2, number), (L:AOA_B787_EXTPWR_3, number).

LVar: (L:AOA_B787_EXTPWR_[n], number) 

BVar get: (B:ELECTRICAL_ExternalPower_[n], number)

BVar set: (>B:ELECTRICAL_ExternalPower_[1]_Toggle)

where [n] is replaced with the appropriate number

RPN Script: 1 (>L:AOA_B787_EXTPWR_[n], number)

System 1 script = no effect

System 2 script = no effect

System 3 script activates the button but sending a "0" in the RPN script does not deactivate the button. I can see the LVar in Dev mode flash 0 but it immediately returns to 1.

MSFS has been restarted prior to all testing. Do you have any suggestions on what I can try? I have cycled through the Initialize and Sync checkboxes but they make no difference.

Those seem to be the same as with the KingAir

LVar: (L:AOA_B787_EXTPWR_1, Number)
BVar get: (B:ELECTRICAL_ExternalPower_1)
BVar set: (L:AOA_B787_EXTPWR_1, Number) (>B:ELECTRICAL_ExternalPower_1_Set)

Remember to map the profile to the plane, and if you do that while AAO is already running, disconnect and reconnect the app.

 

Thanks, yes the profile is mapped to the plane and all of the various liveries for that plane