May 11, 20224 yr I run my Dash 8 Q400 with P3D v5.3 under windows 10. I also have the FS2Crew and EZCA addons.I have a problem when I get to the TakeOff Procedure in FS2Crew - the copilot readouts do not occur and I cannot communicate with FS2Crew until I get to the Climb Procedure.My solution for this has been to turn EZCA off during the TakeOff Procedure and turn it on again during the climb.This is the case at all airports and does noy apply to my other aircraft (PMDG 737 NGXu). There would thus appear to be a conflict between FS2Crew and EZCA during the TakeOff Proc. Does anyone have the same problem? Is there a solution? John McWilliam
May 11, 20224 yr Commercial Member Hi! ESCA 3 is not officially compatible with DASH8Q400. Most likely, only a temporary EZCA OFF remains the only solution. Nick Bebyakin / Handmade cameraset - Ezdok v2 and Ezdok v3 EZdok Software. Support remains on the http://www.ezdok-camera.com/ [email protected] / 20Gb / RTX 2060-OC-6Gb / Win10x64 / MSFS2020
Archived
This topic is now archived and is closed to further replies.