I have calibrated with MFG 2.17 in auto & manual.

Rudder goes through full range from left to right, but stays full right at center (no input).

MSFS set to Modern not Legacy.

All conflicting bindings from other controllers have been checked and eliminated.

Same problem with different aircraft.  (Cessna 172 & PMDG 737)

As an aside, I am able to get rudder to behave normally when programmed with Spad.Next.  (want to use MSFS sensitivity settings though)

Any suggestions?  Thanks

Supporting pics attached

https://www.donaldwmaxwell.com/Photos/FS/i-Jh7QCgL/A

https://www.donaldwmaxwell.com/Photos/FS/i-bQ47Vtt/A

https://www.donaldwmaxwell.com/Photos/FS/i-wdM6T6G/A

https://www.donaldwmaxwell.com/Photos/FS/i-22DhVzK/A

 

Edited June 6, 20224 yr by toothjockey
add photos

4 hours ago, toothjockey said:

I have calibrated with MFG 2.17 in auto & manual.

Rudder goes through full range from left to right, but stays full right at center (no input).

 

I had the same exact issue as you have.

In the end, I gave up using their calibration software and found out about this youtube tutorial. Even is for redbird it turned out to be such a good help in calibration and fixed my problems.

https://www.youtube.com/watch?v=8ecr2lBN7LM&t=864s

Thank you LRBS,

MFG is emphatic that you shouldn't use the windows calibration.

I had tried all solutions I could think of.

So I tried the windows calibration.  Lo and behold!  I finally got the rudder to center!

Then I went back into MSFS controls and adjusted sensitivity.

Thanks so much for your input.

Don