July 21, 20223 yr Not sure into which subforum this message goes. All my life I have had a very trivial and pleasant time removing the backing from velcro. If I had to use my finger nail it would not have been that easy nor fast. So I use these #13 xacto blades (which Xacto no longer makes). But Zona still does. After more than 10 years and hundreds of uses, I still have the same original blade in the knife. The back of the blade without the saw toot serrations is slipped under the clear plastic velcro backing about 100 times easier for me than if using a finger nail. My handle has a screw top over the blade, like the screw top on a fountain pen. I don't see that type of handle for sale any more. The 'safety cap' xacto handles are ok, but the cap falls off because it's not screwed on. https://www.amazon.com/Zona-39-924-Replacement-Blades-5-Pack/dp/B004DIUSFW/ 5800X3D, RTX4070, 600 Watt, one or two 1440p 32" screens, 64 GB RAM, 4 TB PCle 3 NVMe, Warthog throttle, VKB NXT EVO stick, Honeycomb Alpha yoke, CH quad, 3 Logitech panels, 2 StreamDecks, Desktop Aviator Trim Panel. Crystal Light VR.
Archived
This topic is now archived and is closed to further replies.