When I first installed MSFS, I setup my flight yoke, throttle quadrant and rudder pedals, and continued to use their respective profiles for some time (v01).  Yesterday I made several sensitivity changes to the ailerons and elevators, and saved the flight yoke settings under a new name (v02) for an easy back-out in case of problems.  However, things did not work as planned as follows:

• I made the changes for the flight yoke settings, saved the changes as v02 and started a flight.
• When I tried using the controls, nothing worked so I went back to the Controls page and reactivated profile v01.
• I went back to the flight and all controls worked.
• I then went back to the Controls page and made the identical changes to v01.
• I went back to the flight and all controls worked.  What did not work as v02 worked just fine as v01.

This is kind of a bizarre situation so I am wondering if anyone else has seen this.  It seems that saving multiple versions of a controller profile does not work.  I would appreciate any feedback for this issue.

I found that SU11 totally screwed my X-56 profiles. All was working fine before - with multiple profiles (for different aircraft). Now, I can't even get the axis calibration bar to move sideways like it did.

So ... I bought Lorby's Axis&Ohs to try to sort things out. Again - sometimes an A&O profile works perfectly, but the next time you go into the sim some of the axes are no longer recognised. It's A MESS I'm afraid.

Sometimes, duplicating a command in the 2nd slot in the MSFS profile helps.