PC-12 like Formula One car

[Juankapilot]

There is something I can do to prevent the high speed on ground with throtle idle ?

I mean using MSFS2020

Waiting for any ideas. Thank you for your time

[dbw1]

I don't have this but have a look at the N1 for idle speed. On king airs i flew in the rw the idle could be anywhere from 52 - 70% depending on where the condition levers were sitting.

[Flying scotsman]

Hi Juankapilot,

                                 I have had this problem too, leaving the prob thrust lever, even at idle the aircraft gets going like a gazelle from the get go and slowing it down is VERY hard. 

I am using  Honeycomb throttle and it is very easy to turn the  engine off while just trying to slow it down. Hopefully it will get updated

I would also report it as a fault to Carenado and see if you get a response. I found them very helpful with an instrument problem I was having

Good luck

[Juankapilot]

Thank you all for your messages and I really appreciate your help.

I hope in Carenado make some changes to avoid this trouble with one of my favourites planes. I remember when I use this aircraft with Prepar3D and it was perfect. Actually I'm using one fix to calm the gazelle, very simple fix....I'm using Honeycomb Bravo too and I set brakes to the lever used normally for spoilers. Is not the solution of course, but it works for me waiting the possible official fix.

I'm very sorry for my english and I hope you understand. 

Again thank you very much for your time and nice flights

Juan Carlos