April 22, 20233 yr I am building an FMC from 737diysim. Boeing 737 3D printed. I would like to have just the display output to show on a 5" HDMI display. The button would go direct to MSFS via Mobiflight. I would love to use this product.
May 5, 20233 yr Commercial Member I think this is too much of a niche request, to be honest. But feel free to upvote the initial request if you are interested in this feature... Mark Foti Author of aviaworx - https://www.aviaworx.com
May 7, 20233 yr Author Where is the initial request? There are a lot of people building these FMCs. They are here on Discord: https://discord.com/channels/1085487873110835220/1093577983186456647. I can pop out the FMC display in MSFS, but I would like to use your software, which I purchased to fill the display. Is it that hard to make it just do the display?
July 15, 20232 yr Doing the same and didn't want popout. I use this: https://phpjj.wordpress.com/ A little Intel NUC running the 5inch display. Basically it has a CDUonly version that is perfect as the screen in this and runs over the Lan. My Aviaserver just does my overhead (32inch touch screen) only now which I love. Janet Virtual Airline MSFS2020 / XPlane i9-9900K, 1070Ti, 32GB Ram, Honeycomb Alpha
August 30, 20232 yr There are quite a few who would love this on the 737DIYSIM Discord and Forum, we are all using either pop-out or VERY flakey software to do it 😞 Janet Virtual Airline MSFS2020 / XPlane i9-9900K, 1070Ti, 32GB Ram, Honeycomb Alpha
Archived
This topic is now archived and is closed to further replies.