Hi all-

I've installed AOS and have got my trim gage installed and working.

I noticed when looking at assigning my yoke to the elevator, the yoke (YOKO) was not seen along with my rudder pedals (MFG). TQ6 quadrant was there though. Was wondering why these devices were not seen.

Thanks,

Mark

16 minutes ago, newtie said:

Was wondering why these devices were not seen.

"Seen" where exactly? Don't look at the "Device" dropdown on the assignment dialog, that is not what it's for - just move the external control without doing anything else

And check "Hardware->Device Blacklist" if these controllers were causing trouble of any kind.

Just for the record, I have MFG pedals too, they work just fine with AAO.

You are absolutely correct. It's all right there in the manual. 😁