Someone have a suggestion on how to do this? I have CP but leaving it out of this as I'm troubleshooting a problem and am using stock views for the time being. I did a search and found a few sites relating to modifying the camera.cfg but it had to do with F11 assignment.

Thanks,

Mark

I use FSUIPC to assign a key press to a joystick button - so when I press the joystick button the S key is pressed, which cycles through the default views. You could also assign a specific key press for that view. I think this FSUIPC functionality is included in the free version.

4 hours ago, newtie said:

Someone have a suggestion on how to do this? I have CP but leaving it out of this as I'm troubleshooting a problem and am using stock views for the time being. I did a search and found a few sites relating to modifying the camera.cfg but it had to do with F11 assignment.

Thanks,

Mark

Hello Mark,

you have AxisAndOhs, right?

There is an AAO command to change the view in P3D to the named cameras (=the names that they have in the P3D right-click menu). You can use it in an RPN script and assign it to your desired button(s)

Examples:

(CHANGEVIEW:Spot)

(CHANGEVIEW:Locked Spot)

(CHANGEVIEW:Virtual Cockpit)

etc.

If you need the P3D V6 version, send an email with your proof of purchase to the AAO support address (last page of the manual) (plan is to release that version on Friday).
But the P3D V5 version of AxisAndOhs will work just the same for the time being.

If you need further guidance, please visit the AAO support forum here on AVSIM.

Edited July 11, 20232 yr by Lorby_SI

I will see you over there.