Two Events on one axis?

[kenny584 77]

Hi Folks.

In FS2020, I use a Bravo Throttle Quadrant. I am trying to assign the DA62 FUEL CONTROL levers to two levers in the Bravo. The OFF position works fine as it is a button in the Bravo, However, although I can get the Bravo lever to set the ON position, I cannot get it to return back to the CROSSFEED. I was planning to use the detent stop in the Bravo axis lever.

Is there a way to have two EVENTS on the one axis lever? One going forward to ON and one coming back to the detent for CROSSFEED.

Cheers...Kenny.

[Lorby_SI 2,078]

What events would that be exactly?

Those two levers are managed by BVars.
On the Add/Change Axis dialog:

• Type "B:FUEL_Cutoff_Crossfeed_1_Set" into the box where it says "Enter Variable"
• Set "Axis Min" = 0, "Axis Max" = 2
• Set "Rounding" to "Int"
• Assign your hardware lever
• Save

You may have to reverse the axis.

Same for the second lever, the BVar is ..._2_Set.

Edited November 3, 2023 by Lorby_SI

[kenny584 77]

Hi there.

Thanks for sorting that for me. Again, my lack of knowledge, but learning all the time. I'll do what you say and report back. This is my flying night with my flight buddy.

Best Regards...Ken.