I have noticed with SP1/SP2 that tree autogen in the Vancouve+ area seems to be EXTREMELY dense, compared to any other area. I do not recall this being the case with RTM, as the autogen in V+ was consistant with other locations.It looks like the V+ autogen has almost doubled in SP1/SP2 at the given setting compared to RTM. Is there a reason it would be so much more dense with SP1/SP2? It seems my V+ performance has actually DECREASED at any given setting due to this.

Did you used the same PC and settings with FSX RTM?

I have not noted a change in density, but you can always adjust your autogen levels to your preference, via the slider or FSX.cfg tweak.EDIT: here's the link to that tweak:http://blogs.technet.com/p-12c_pilot/archi...might-help.aspxAces may have played with density settings, I'm not sure.Jon

Hmmm, maybe I'm just seeing things then. lolThanks

No worries. Drop by the support forum if you have any problems.http://forums.fsaddon.eu/viewforum.php?f=15Jon

Hi Jon,Don't mean to hijack this thread. But I saw in your website thisQUOTE:--------------------------------------------------------------"Installing Acceleration? SP1? SP2? Land where there should be water?Filed under: FSX, Flight Simulation, Flightsim, Vancouver, Victoria

Hi Manny,When does the "File not found" error occur? Under what conditions, and in what part of FSX? That is unlikely to be caused by a problem with terrain.cfg. If you have one of the addons noted, they simply don't display properly, fore xample you'll have land where there should be water or other funnies.Vancouver+ uses primarily default runway textures, although there is a little bit of custom texture at CYPK. The runway/taxiway locations are all corrected to the real-world locations/widths/markings.Jon

I have not been able to figure out the pattern where exactly or under what conditions it happens. Unable to recreate the problem to get that error at the time I want.I am happily flying away..and suddenly I get that popup. Sometime, when I change my flight and load one of old saved flight, I get that. But when I go there again or try to load the same scenery at another time, I don't get it.Manny

Manny, ensure you've disabled all your addons and see if this still occurs. If not, enable your addons one at a time until you find the culprit.What options are you presented with when you get this message? This is with SP2?Jon

Yes..its post Acceleration (SP2). But I don't believe its that... I started getting this only about 2 weeks ago. and I did install a few stuff. and updates on certain addons. I lost track of what I did during the two weeks.As far as option..I get nothing. When I ack that pop up, FSX quits.. it just drops out.Manny

I think, I may have found the culprit/offending addon.Its Cloud 9 products. I actually tried out Bergen airport and then had to restore my system by a week for something. Since then I have been having this problem.http://forum.fscloud9.it/viewtopic.php?p=2...6d200ec0dcb3724Now, I am stuck..I can't get rid of this virus like issue.Manny

Hi Manny, thanks for checking back in. I'm not sure, from that thread, why you're stuck though ...Jon

I had installed Cloud 9's Bergen scenery two weeks ago to check it out. and I see other folks who had installed it having the same problem. I am trying to uninstall and remove all cloud 9 from my registry etc to see if I could get rid of this error.Manny

Roger that, Manny, I'll leave it with you and Umberto ...Jon