I have been using Pilot2ATC v2 with X-plane successfully for some time from this Airport

I find that when I am at NZAA I cant contact ATC, it works fine at other airports such as NZWN

when i connect at NZAA I can hear Atis and I am given the ClrDel Frequency correctly in Standby in P2ATC

When I xfer to ClrDel the correct Frequency is shown in the Active Frequency box but the text underneath changes to '----' from NZAA CLrDel
It is also correctly shown in the sim. But the Speech Assist box in P2ATC is is blank and I get no response to voice transmissions.

It all works at another Airport

Is there a way to "repair" NZAA?

Thanks

Are you running P2A version 0.0.24B?

That works for me at NZAA.  

Dave

Hi Dave
No I am running Version 2.7.0.2_x64

This is a problem that continues but only at NZAA, as soon as I am out of the Area the next Airport and Center work fine, leading me to think that there is some sort of corruption within P2Atc

If it works elsewhere, then the problem is likely with the data, not P2A.  It could be the position of the ClrDel controller at NZAA is further than 25NM, which is the radio range limit when on the Ground.

Dave