When setting up trim buttons on my yoke in MSFS2024 I noticed there are separate options for Trim Wheel and Trim Yoke up/down, as wel as the existing Trim (nose up/down) options.

Does anybody has an idea why there are separate settings for these which basically control the same variables?

No one has a clue?
This is what I am wondering about:

Edited November 25, 20241 yr by Allard
added a 1000 words

I use elevator trim up and elevator trim down commands (not axis commands). I put them on my VKB Gladiator stick.

There is an encoder up down wheel and also a repeating up down switch on this stick. And an axis lever in between those two on the Gladiator, near the bottom.

I put the same up and down commands to both of these, the wheel and the repeating switch. When I thumb the wheel up and down, the trim changes very slowly. When I thumb the switch up and down, the trim changes very fast.

No adjustments are necessary to do this trick. An encoder works slowly. But a repeating switch works fast (for example you open notepad and hold down the c key. A series of ccccccccccc is output). The keyboard c key is a repeating switch.

If you have a yoke and a controller like the Bravo, you will have both the elevator trim switch on the yoke and a trim wheel on the throttle quadrant.

13 hours ago, eslader said:

If you have a yoke and a controller like the Bravo, you will have both the elevator trim switch on the yoke and a trim wheel on the throttle quadrant.

True, but the default assignments for the Bravo are ELEVATOR TRIM DOWN en UP. I used the same for my Fulcrum yoke which works wwll..
Perhaps I just have to try and see if there's a difference. It might be that these specific settings have different sensitivities.