I am using RealTurb v2 with MSFS flying the Fenix A320. I set MSFS turbulence settings to Low as advised by Fenix but I’m not sure about the appropriate RealTurb settings.

Could please someone advise the most realistic settings within RealTurb v2 for the Fenix A320 within MSFS2020. Thank you so much.

 

Kind regards,

Tilo

The only tip I can give you is if you are using REALTURB in FS2024 and you are flying into or out of an airport that reports restricted visibility, then turn REALTURB off. There is a BUG that causes extreme turbulence when entering or leaving the fog layer. You could lose control of the aircraft. (This affects ALL aircraft in FS2024).
I have already reported it, it will be fixed with a next update by the developer. 
And it only affects FS2024.

Translated with DeepL.com (free version)