April 21, 20251 yr Everything OK until yesterday. Previously I had updated NVIDIA Driver to latest. Now, I get a message in Red Loaded from Master: Fenix A320-Easyjet etc It works, I can use X TOuch Mini and the VrInsight FCU(with bridge), just cannot make any changes
April 21, 20251 yr Commercial Member 2 hours ago, Tezbedz said: Everything OK until yesterday. Previously I had updated NVIDIA Driver to latest. Now, I get a message in Red Loaded from Master: Fenix A320-Easyjet etc It works, I can use X TOuch Mini and the VrInsight FCU(with bridge), just cannot make any changes Have a look at the manual, page 13, chapter 3.4 Master configuration and „clones“ Click on the question mark in the top menu bar of the AAO app to open the manual. Edited April 21, 20251 yr by Lorby_SI LORBY-SI
April 22, 20251 yr Author In 3.4 it says Clear Current config. I dont have that option I have: Save current Config Reload Current Config Select master Config for this aircraft Apply other config to this aircraft Delete Current Config Empty Current Config Ive tried Deleting current config, and aply another config Ive tried Select a Master Config But I cannot get rid of the Loaded from Master Fenix A320-Easyjet Nantes. In the past if I changed livery all I had to do was uncheck the tick and apply a template? Thanks for your help, I dont know what I have done, unless it is a dodgy livery?
April 22, 20251 yr Commercial Member Sorry, but I don't understand what the issue is. Your OP reads as if you've never seen a master/clone configuration before. That is why I directed you towards the manual. 3 hours ago, Tezbedz said: In the past if I changed livery all I had to do was uncheck the tick and apply a template? This then sounds like you do know what a Clone configuration is - why are you not following the same procedure here? Edited April 22, 20251 yr by Lorby_SI LORBY-SI
April 22, 20251 yr Commercial Member If the red message doesn't want to go away, check if you have a duplicate of this configuration in the database. There should only be one, but I've seen before that sometimes two are created somehow. Disconnect from the simulator (click on the green LED at the top so it turns dark) Open "Templates->Edit configs" Look for the configs that have been created for this new livery and delete them. They may hide in the section just called "config". But normally they are under the name of the "Master" aircraft DO NOT DELETE THE "MASTER", make sure to only delete the clones for the troubled liveries. Close the dialog and then click on the yellow hard disk symbol of the bottom of the AAO main dialog. Shut down and restart AAO Edited April 22, 20251 yr by Lorby_SI LORBY-SI
April 23, 20251 yr Author 18 hours ago, Lorby_SI said: If the red message doesn't want to go away, check if you have a duplicate of this configuration in the database. There should only be one, but I've seen before that sometimes two are created somehow. Disconnect from the simulator (click on the green LED at the top so it turns dark) Open "Templates->Edit configs" Look for the configs that have been created for this new livery and delete them. They may hide in the section just called "config". But normally they are under the name of the "Master" aircraft DO NOT DELETE THE "MASTER", make sure to only delete the clones for the troubled liveries. Close the dialog and then click on the yellow hard disk symbol of the bottom of the AAO main dialog. Shut down and restart AAO Thanks very much for your help, its all sorted now, apologies for not explaining the problem as well as I should
Create an account or sign in to comment