December 2, 2025Dec 2 I have the following problem: when I start entering the departure airport, I get the following error. I already followed the instructions in the manual using the "MakeRwys" program and it still doesn't appear. I also tried disabling the following option and it still didn't work. On the other hand, when I enter through "Taxi mnt", the airport is shown with its gates and runways. When I click "save changes" and go through the flight creation process, it still doesn't appear.
December 3, 2025Dec 3 Commercial Member If you make changes in Taxi Mnt, you have to shut down and restart P2A for the changes to be loaded into the active data. Dave
December 4, 2025Dec 4 Author On 12/3/2025 at 7:37 AM, Dave-Pilot2ATC said: If you make changes in Taxi Mnt, you have to shut down and restart P2A for the changes to be loaded into the active data. Dave It doesn't work either.
December 5, 2025Dec 5 Commercial Member If this is an airport not in the database, then you also must check the Runways tab and ensure you have runways defined there with Takeoff and Landing capabilities.
December 7, 2025Dec 7 Author On 12/5/2025 at 7:49 AM, Dave-Pilot2ATC said: If this is an airport not in the database, then you also must check the Runways tab and ensure you have runways defined there with Takeoff and Landing capabilities. The same error persists; everything is configured but it doesn't appear when creating the flight plan. Edited December 7, 2025Dec 7 by wilivarob
December 9, 2025Dec 9 Commercial Member When importing airports, Airports are created from the Runways.xml file, along with the associated runways. Did the runways get created when you did the import?
Create an account or sign in to comment