Hi there.

I have earlier experienced that my Sismo board randomely stops working when using PSX Traffic. I have been away for a long time, but have now updated to the latest verison. Now everytime I use the RT APP mode, it stops working. If I then switch to RT Direct mode, and reset the Sismo board, everything works out perfectly.

I have seen the FAQ answer, but I think my Prosim is to old (still version 2.xx), as I cannot find any options to set it to FSUIPS rather than Simconnect ( it looks as the primary connect from Prosim is via FSUIPS, and secondary via Simconnect).

I could of course just use the RT Direct mode, but I really (like in really!) miss the radar on the RT app, with all the ADSB data, including AP settings.

If any light could be shed on this error or alternate ways to get the same radarview, I would really appriciate.

I thank you in advance.

Bjarne Sorensen / Denmark

I don't think Simconnect is the issue because that can very well work in parallel. In RT-Direct mode, PSXT also uses Simconnect.

Maybe it is a port problem? See the manual in section 9.7. Change the port number in PSXT and in the RT app.

Thanks for reply.

Tried changing the port to 2343 (just a random figure), and RT and PSX connected, but Sismo board stopped working again.

Brgds
Bjarne

3 hours ago, SorensenDK said:

Thanks for reply.

Tried changing the port to 2343 (just a random figure), and RT and PSX connected, but Sismo board stopped working again.

Brgds
Bjarne

Well I do not know the Sismo board, maybe other Prosim users can help you? I know that @GSalden uses Prosim...

Yes, I use Prosim. I use a CpFlight hardwarev ( ethernet connection ) and OpenCockpits hardware, not Sismo hardware. Never had any issues with PSXT because of that.