Merry Xmas everyone:)Need some advise on using Notam'sI was flying into KDEN with the Notam checked when flight plan loaded into RCV3.Prior to arriving at Denver I was advised to decend to 15000 if feasible which I understand.Co-Pilot advised we were leaving to get the weather and was advised that rwy 25 was the active winds 230@10 makes sense.After that transmission a selection popped up as follows change destination which I ignored as I had intended to land at Denver.I was never given any other instructions after this but could have selected cancel IFR but did not.It was evident that I was not going to be vectored into rwy 25 so I set up fsnav and landed without a hitch.The only transmission I received from RCV3 was an altimeter check approximately 10 times prior to landing.I landed with no switch over to tower, and never could request wind check.Once I landed I was never requested to contact ground or leave the active.I then clicked onto cancel IFR and RCV3 closed off.I might add Co-Pilot told me "Your Plane" after the weather check.Is there something I am doing wrong.Tks. for any adviseKenny G.

somehow you keyed the menu item to request change of destination. don't ignore it, press CAN. that is probably why you never heard a peep, it was waiting to see where you wanted to go

Tks. JD will take your advise.Merry Xmas to you and your familyKenny G.