Sign in to follow this  
A320driver

Voice problem after 4.2 update

Recommended Posts

After installing the 4.2 update, I cannot get any of the voices to change. Whatever they were on before the update is where they stay. Downloaded and installed a voice set, see it on the voice selection screen, check it click save and still no change. Ideas?Thanks,Joe

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

i don't understand your question.where can't you get voices to change? in flight? on the voices screen?did you select more than one controller? can you not change from one pilot voice to another?jd

Share this post


Link to post
Share on other sites

where can't you get voices to change? in flight? on the voices screen? I select the voice I want to use (on the voices screen) by checking the circle to the left of it. I click save. I never hear the voice I "checked", just the same one as before selecting another voice. Before the update I would follow this procedure, go to the "general" tab, click the sound button and hear the voice I had just selected. Also, no matter what country the pilot or controller is from, the flag icon on the voices page shows the stars and stripes.JE

Share this post


Link to post
Share on other sites

you can't change voices while rc is running with flight simulator. only before rc starts running with flight simulatorif you only see the start stripes on every pilot, controller, etc, you did do the step of upgrading from 4.0 to 4.014.2 requires you have all the voice sets that are part of the 4.01 update.jd

Share this post


Link to post
Share on other sites

This voice change I am refering to is before I start flight simulator.What I mean about the stars and stripes is I used to see the flag in the upper right hand corner of the country the "voice" was from. Now I get a U.S. flag, no matter where they are from. Have done all the upgrades sofarJE

Share this post


Link to post
Share on other sites

start rcv4click debugload your .plnclick startclick stopzip up the .log and send it to mejd

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this