garyghostrider

You might try running this .bgl file with 3-D remover by Torsten Wille..File is remover10.zip in the avsim file library..this program does work in FS2004..Hope this helps.Gary

Hello Pilots, Just wondering if anyone has the catapult data for the USS Nimitz located off the coast of RIO de Janerio (nim_rio.zip) using the excellent carrier ops package (RCBCO-20.ZIP)..I have tried every which way I can following the directions to add the data but I can't get it to work..Any help appreciated..Thanks!!Gary

Hi Arno,I haven't run it long enough to know that for sure but I wasn't having any trouble with the AI taxiing/taking off before the fix..the only trouble was with the water island..so hopefully all is still OKGaryOh P.S...you can use JABBGL to adjust AI elevations in your AFCAD2 files..I tried it for the 1st time on this file :-)

Hey Arno, Jose and everybody, Following advice I received I think I have this problem fixed:The solution is to use FSTflatten and create a flatten area around the ship with elevation set to 0..Seems to be working OK so farGary

Hi Jose, I have tried to make flatten "switches" but it only made things worse..I like the idea of the invisible runway at sea level..How do I create that??Gary

Hi Arno, I am beggining to believe you are right that this problem may not be fixable..However, there is an AFCAD2 file that works with a carrier made by Robert Baum for the scenery off Rio De Janeiro...I have tried contacting him to see what magic trick he pulled to make it work but I have not heard anything from him yet..Oh well, Thanks for the input!!Gary

I am not sure if this is the correct forum to post this ?? My apologies if it is not :-)Hello, I have been trying to put together an AFCAD2 file for the USS Stennis locatedoff the coast of California. I have run in a problem that I cannot seem to find a solution for:I have tried various adjustments to the elevation and also made a flatten "switch" which only made things worse. When I drop the elevation, the water goes back to normal level but the AI traffic also drops down too low. Any ideas on a fix for this would be greatly appreciated.Gary

Well I tried replacing both scenery and texture folders in Scenery/World/Scenery folders...no go still stuck...Will check back for any further replies later..Thanks again!!Gary

Hi CargoMan,I cannot remember if I have tried that fix or not before but it sure is a good idea..I will give that a try.. Also will have a look in Modules but I think the only thing added in the was FSUIPC..but it can't hurt to check there as well..Thanks!!Gary

Hello Everyone,I am having a problem in FS9 that I cannot solve. When I try to fly to or start at the default KSEA airport in daytime (after 700am local) FS9 shuts itself down.Everything works normally at night but when daylight hits is when I have troubles. I have tried :1.Removing any custom AFCAD2 files and just running the default.2.Removing and re-installing the default scenery and texture files for KSEA contained in FS9/Scenery/Cities/Seattle.3.Removing and re-installing the entire default Texture folder.4.Examining the scenery.cfg file for errors (found none).I have done all I can to undo any changes that may have been made to this airport but nothing seems to work.I have noticed that the ground (earth) textures in and around the airport appear to be missing that is why I concentrated on the texture files. If someone is willing to help me on this I have screenshots available that show the problem just before FS9 shutsdown. 1 other note, I can run in slew mode at all times of the day but not in normal flight mode. Any help appreciated.Thanks!Gary