frank155b
Members
-
Joined
-
Last visited
-
Thnx very much! :-)
-
Can you please elaborate on the FSUIPC settings? I have setup the Joystick Calibration in FSUIPC as specified in the manual but what about the Axis Assignment? Do I set Send to FS as normal axis or Send direct to FSUIPC Calibration?
-
I always use FSUIPC to configure my controllers. There is a reason for that because the MS control setup is rubbish. In order to fly the bus I unplugged most of my devices but I can't get it to work properly :(I managed to get the throttles working but the behavior is erratic to say the least. There is a conflict somewhere but i cannot figure it out. Also I have CTD's when I close the sim, which is not nice since I then need to redo all the MS control setup! I was so happy to that a nice Airbus is finally available for FSX that I bought it immediately. Knowing of all the config problems I wouldn't have bought it. :(
-
After 2 hours I have been unable to configure the throttles. :( Normally I use FSUIPC for all joystick calibration. Unfortunately it is required to configure the throttles via the FSX control axis menu. I always disable controller in this menu to prevent problems since I have many controllers attached (Saitek yoke, 2 Saitek throttle units, CH throttle quadrant, CH rudder pedals, Logitech joystick.)Anybody else having similar problems? And yes I have read the Vol1 guide Q and A ... Going to eat now and try again later...
-
Hi thereI am having problems with several FS2004 planes in FSX with regards to VC lighting. As soon as I switch on any light I get these strange textures. Anybody an idea what is going wrong here?http://forums.avsim.net/user_files/189204.jpgAircraft in the picture is the fantastic freeware HS748 by Rick Piper.