philipe

Hi Sorry not used Vox ATC for 6 months or so but just getting back into FSX again now the nights are drawing in. I seem to remember I had the same issue and it was very noticeable at large airports eg Schipol/Heathrow etc. Now I was using Mytraffic for traffic and I found that I needed to edit the afcad for the airport such that each runway only allowed either takeoffs or landings (not both) for the airports where this was an issue. There is a software program I used to do this for me I think called Airport Design Editor and there are instructions within it as to how to amend runway operations (it cannot have been to difficult or I would not have been able to do it!) and from memory this sorted a lot of these sort of issues out for me. The only issue is that you have to manually edit each airport where this is an issue. Hope that helps a little sorry I cannot add any more as it was all over 6 months ago and the memory fades as to exactly how I did it.

Thanks for your replies. I have also noticed aircraft getting stuck at end of runways and not taking off but mainly while watching from top down view to check AI is following the taxiways etc.

Just wanted to say that I am really enjoying VOX ATC - ease of set up, immersion and general handling of AI once in air. However, I have noticed a few issues on the ground and wondered if these were normal and whether other users get them as follows:1. If I get too close to another aircraft when taxiing it often vanishes completely (I assume this happens to other users?); and2. I also get some of the AI on the ground getting lost i.e. the odd aircraft wanders off the taxipaths. This may be an AFCAD issue and I have only really noticed this at add on airports (this is where i tend to fly through) but I have removed the duplicate AFCAD from the Mytraffic folder (using the freeware scruffy duck tool). Does anyone else get this issue/are there other AFCADS I need to delete?Thanks in advance - for information I use FSX with Mytraffic 5.4 for aircraft.

Thanks for your reply I had a look at a Heathrow UK2000 Scenery last night and that was using different runways for take off and landing all be it they were opposite directions take off on 09R and landing on 27R so must be something to do with AFCAD. I will update tonight and check again - I assume new AFCADS that cope with multiple runways can be found for stock FSX airports on Avsim?

Just bought Vox ATC and really enjoying it but had a couple of related queries as follows (by the way I use FSX, Mytraffic 5.4 and default scenery): Can VOX ATC cope with multiple runways as I flew into Schipol last night and every aircraft was having to take off and land from the same runway which meant there were literally 20+ planes waiting to take off which also meant when I was taxiing on the ground I was directed into path of aricraft taxiing to the one take off runway; If answer to query above is no then presumably a lower traffic volume level will resolve this log jam on the ground if so what traffic setting to other users use and can this be changed mid flight? Thanks in advancePhil