Mark_L

So out of the blue I can suddenly access http://www.orbxsystems.com/forum/ But the only forum area I can see at all is: Oculus Rift and VR headsets discussion Where's the rest of it?

So I haven't checked and upgraded for awhile and found that my FTX Central version 1 was updated along with other North America and Australia regions I have. Their forum support site does nothing but throw 500 errors, so no access there. The hard drive on my system failed last fall so I had to reinstall everything and patched and upgraded with everything I could find. Here's the issue I'm having, when loading 1S2 Darrington Municipal, the taxiways and runway elevation is messed up. Like about 20' feet below the surface. So I am running FTX Central v2, I applied the region, did some basic checks, where do I look/go to fix this? Thanks for the help in advance. Mark

June 1, 2016 I still unable to access without the error. Anybody have a clue as to what's going on with their site?

Not sure what has changed, worked fine last week, just too jumpy and needs some tweaking, now it brings my system to it's knees when clicking 'Start'. After clicking 'Settings' and Stop and Start a couple of times, it will finally start to work, promptly followed by a critical error with the debugger (I have Visual Studio on my box) prompting if I want to debug. If it does get further, attempting to change the curves to tweak my settings, it will crash everytime.

Ok, Read the manual, I'll play with some settings and see what happens. Didn't realize that info was there. Up till now, it's been pretty decent, I think part of my issue is the webcam is too close as it will drop when my head points down to far or left or right.

Ok, I finally figured out that I had to configure the keyboard shortcuts to something that was valid that would 'center' the view. A little more documentation would help with this to understand a few things. What are the EWMA Red factor sliders and there impact? I figured out the 'Invert' portion, but would like to know what impact these sliders have. I've played with them with really impact that I've noticed.Mark

Need some help here. I realize this is the FS2004 forum and I'm using FSX, but didn't see any other relevant threads elsewhere. Downloaded and installed and it's working pretty good except that I'm looking at the rear of the plane/cockpit. Using the Cessna 172 to keep it simple, by the way using a Logitech QuickCam Pro 4000 ( to add to the compatibility test ). So why is it defaulting to the rear of the aircraft? How to I fix this? I also have EZDOK installed, enabled or disabled, no change.Thanks for any help, Mark