kdt
Members-
Content Count
27 -
Donations
$0.00 -
Joined
-
Last visited
Community Reputation
1 NeutralFlight Sim Profile
-
Commercial Member
No
-
Online Flight Organization Membership
none
-
Virtual Airlines
No
Recent Profile Visitors
The recent visitors block is disabled and is not being shown to other users.
-
Yes it is physically moving. i have check with engine on and engine off but pushback does not work with rudder. Klaus
-
Hello the rudder control does not work with the PMDG 737. thanks for help Klaus
-
I have deleted all LUA data, I think things are going better but not yet 100%. I still have to test. Greeting Klaus
-
hello,no matter what I do the acceleration height does not work. I set the altitude to 1000ft AGL with the MDA Knob. But the FO says Acceleration Height at 100-200 ft. It makes no difference whether Linda is on or off. Mfg Klaus
-
no, i don`t use LINDA. Klaus
-
this has nothing to do with the hardware. These problems also occur when the hardware is uninstalled or not connected.
-
is there anything new because of the problems?
-
So the only possible one would be the GoFlight Interface Tool. But in the matter I do not know myself. But I'm typing on fscrew because as I mentioned above, the problem with PMDG and Maddog X does not occur.
-
Hallo DeCaf, i don' t use spad.next. Klaus
-
I still have LINDA CFG on YES and still have the problems mentioned above. and i don´t use LINDA. Greeting Klaus
-
the problem with "1000 to go Alt Sel" is solved in my opinion with the activation of LUA YES in the config.
-
hello I use the Goflight MCPPro when I activate fscrew flashing allle LED`s on MCPPro which does not bother so much. But if I issue the command set heading XXX or set IAS XXX during the flight, the settings will run in an infinite loop. You can not stop that. I also have the problem that V1, Acceleration Heigh and QNH are announced too early or completely wrong (QNH). LUA is set to YES in the CFG. These problems only occur with the Dash 8, but I do not have the problems with PMDG or Maddog X. thanks for your help Klaus
-
the command "Flaps 0, IAS 185, climb checklist to the line" is not executed although the command is displayed correctly in the text line. For the FO repeats constantly "1000 Feet, Alt Sel" Everything works fine until the takeoff and initial climb, no problems. thanks for your help Klaus
-
the problem was or is the following, if on Ground the Flapselector is not stowed, then the copilot does not set the Flaps down on Ground, and also he doesn´t set the Flaps up in Climb. Mfg Klaus
-
sorry not after the landing but during the landing approach the flaps are working. And yes I see the green bar there is "flaps up" but nothing happens. mfg Klaus