park86

I wish that would work but is doesn't. I have recalibrated several times both within FSX and with the CH control and the problem persists. It behaves as if I didn't disable the realistic setting which I did.

I would like an answer to that too. After about 15 - 30 min in flight the a/p disconnects if I move the hat switch but OK initially.

The intro manual answered my issue. Yes, it is sometimes useful to read the manuals!. If realistic a/p is set to on the the airplane must be trimmed and FD centered for a/p to engage. Pretty impressive.

I have adjusted the null zone and same problem even when touching the hat switch. Only happens on this plane.

I assume I adjust the nul zone in fsx, right?

Sorry to ask this but how do I change the nul zone. I calibrated with the ch utility.

The autopilot disconnects if I touch anything on my CH yoke like the hat switch. I know it is supposed to disengage when the controls are moved but the sensitivity with this is extreme. I have recalibrated several times and do not have the problem on the 737 ngx or 747. Anyway to change the sensitivity or turn it off completely?

No because the autopilot kept disconnecting but I found my problem. It was my ch pedals. I re calibrated and now doing my first flight klax to ksfo. So far so good. Thanks

Just started with the 777 but the autopilot will not stay connected. It will briefly then disconnect. I do not touch the yoke or pedals but it still disconnects. I have been flying both the NGx 737, 747 and many others without any problems so I do not think it is my controls. Calibrations look good and again, works on all other planes. I do use EZdok but problem still there when I disconnect it.

Thank you. That did the trick. I guess timing is everything.

Ok, I am not happy and I am not completely computer illiterate but I cannot get rc to work. I have w7 32 bit and open the progam as admin. I can get the call out to respond but when I start rc after being in "fly now" mode in fsx, the atc window is red and will not accept or respond to any commands. I have searched this forum to no avail. For 44 bucks, there should be a straight forward answer. Does anyone have one?