Fusions

Mark, Thanks for this will try tomorrow. Ian

Hi guys, does anybody know if this works in version 3.2?? I used to have ut2 working in version 3.1 but did a clean install when I updated to Windows 10 and although I got traffic working again in 3.1 I got a DLL missing error on startup. Have just done another fresh install of Windows 10 and looking to download P3D again fully version 3.2. My copy of migration tool is the latest on their site which is a later version than the one you mention Richard. Thanks in advance Ian

Hi Guys, More a question than a problem but since installing UT2 into P3D Ver 3.2 when i start the sim i get the following message pop up There was a problem starting D:\ Prepar3D The specified module could not be found clicking ok starts the sim with no apparent issues but when I close down again the message comes back. Any idea's please??

Hi guys, Anybody else having problems with 6.52 in P3D 2.5?? Mine seems to stick on initialising and if I disable then enable again it seems to load further but just get asked to tune into tower but no options as what to do next. If I disable again and restart still not getting any further. Have reinstalled software from scratch but still no luck. Ian

Well that's a bit strange as there is most certainly a my traffic entry in both CFG's on my set up! Tegwyn requested I sent him copies of both and his solution was to do what I described above which I did. Nothing incorrect about it. I can't say if it's the same on everybody's set up its just what worked for me.

Hi OmniAtlas, You seem to have the same problem as me! I contacted Tegwyn and problem for me seems to be resolved by doing the following... 1, If you only have P3D installed then Vox 6.51 doesn't work, you need to use version 6.5 2, Then go into c\programdata\Lockheed Martin\P3D v2 open the file simobjects.cfg Find the My Traffic entry which will be something like [Entry.9] "Mytraffic6\Mytraffic\Aircraft" and remove the quotes from around the entry and then save the file. 3, Then open the file prepar3d.cfg in C\users\your user name\Appdata\Roaming\Lockheed Martin\P3S v2 and find and change SimObjectsPath.9 "MyTraffic6\MyTraffic\Aicraft" entry and again remove the quotes. Save the file and exit. Run the indexer again. Now your entry may look slightly different to mine depending on what drive you have saved to but this worked for me so hope it does for you too. I have tried to attach the 6.5 file for you but for some reason it won't attach but if you look at some other posts on this forum about this problem it is there as that's where I got it from! Cheers and good luck..

Jer29, thanks for the tip but managed to get hold of Tegwyn who sorted the issue for me. Thanks again anyway.

Sorry guys but can anybody help me? Have read previous posts about VOX and P3D 2.5 having some issues but still can't get mine working. I have never used VOX before and have P3D 2.5.12945 installed as my only simulator and trying to get VOX 6.5 to play (I know 6.51 has issues when P3D is only simulator installed hence using 6.5). All seems to go ok until I try to load VAPanels then it just crashes with VAPanels has stopped working message. Have kept checking the forums and emailed the developer about a week ago but had no response as yet. Any help will be much appreciated as I'm really looking forward to using this programme. Thanks in anticipation Ian