markmco
Members
-
Joined
-
Last visited
Solutions
-
markmco's post in Saitek Panel/Driver/SPAD Problem or Phenom? was marked as the answerI do miss the panels. Hoping the v3.1 P3D update will address this. In v3.0 most aircraft do not interface (or partially so).
-
markmco's post in Lear Yoke and Roll was marked as the answerResolved:
It wasn't P3D or the Lear, but user error.
Controllers were enabled. I had created a profile specific FSUIPC axis control last week. FSUIPC wins for control ...on the second flight? Don't know why, but it's re-calibrated and working now.
Disabled controllers in P3D and the surfaces work fine. Can't get steering or reversers assigned in FSUIPC, but I'm working on it.
-
markmco's post in PC Aviator Australia Down? was marked as the answerJust downloaded this morning. It is v1.6.
-
markmco's post in P3D v3, Smooth Takeoff then Stutters, Beeps and Requires Power Down was marked as the answerFinally had a chance to try this. I just disconnected the trim wheel. Tried a few hours of test flights and everything worked fine.
A big thank you to those that pointed me in the right direction. I am now using the smaller Saitek trim wheel in the auto pilot module. It works, but is very slow. Adjustments in SPAD haven't made a difference. Anyway, that's a minor issue until I try the dedicated trim wheel again.
Best,
Mark
