kotzejohan

Hi Charlie, I download the file, it look as if this update is for VC. I only fly 2D.

Thanks Charlie

I am at a vice here. I am using FSUIPC 4.977 with FSX. I build a throttle quadrant with 2 fuel cut-off levers, below the throttle levers. My controller board is a Leo Bodnar BU0836X. I am using offset 66725, parameter 1 for lever 1 (on press) which start engine 1 and the lever on screen moves in the up position and start engine 1. But when I use offset 66725, parameter 2 for engine 2 it starts engine 1 and no movement on the engine 2 cut-off lever. So I delete the config of engine 2 fuel cut-off lever. Doing a test, remember no config on lever 2 but when I flip lever 2 engine 1 try to start as if there is a invisible link between them. I looked in FSX controller panel and delete all joystick events, I even unselect "enable controllers". But can't get engine 2 fuel cut-off switch to work. I am a bit rusty on this and help is appreciated. When you hover with your mouse over the fuel cut-off levers the info tip display "Master starter switch"

I notice that the default B737 vertical nav bar in the pdf is missing when in nav mode only the horizontal is visible, it was there before. I switch to other default planes like Airbus321 and B747 and also find that the vertical nav bar is nav mode is missing. When i open the pfd in FS Panel Studio the vertical nav bar is showing

Thx Charlie, I did download it.

Is there a weather radar that is integrated with default 737 MFD. Is see that the efis has a weather button but not active.

@ David Vega, thanks for the reply, the default B737 radio stack is not part of the main 2d panel but available when Shift+2 is pressed or from the drop down menu. I want to modify it by taking out Comm2 & Nav2 so that I can make the gauge or Radio stack panel smaller to save space on my 4th screen. As Maddogz point out to me is that one might mess up the X & Y coordinates and I am not very glued up with panels. I did bought awhile back FSPS but also struggling to use that. Maybe I must just search to see if there is Radio panel that will sued my needs.

Is there away to modify this gauge as I need some space on a screen. I do not need comm2, nav2. I use 2d panels and have 4 monitor setup. I did take out the comm2, nav2 from the gauge in the panel.cfg by add // infront of the line. But now its black boxes so I do not safe space?

Thanks

Yes you did, thanks

For an Airbus FDU

Yes Charlie

Do anyone have or know of a MFD gauge with terrain and weather display then I can swap with default B737 MFD? Freeware please

Where is b737-800 radio stack bitmap located, I search FSX but can't find it

Thanks