Slayer68

If I remember correctly it's on the floor try clicking the boot where it comes out of the floor.

Triggering the LVAR will not always trigger the animation. You'd have to dig into the XML and see what drives the animation code and trigger that too.

Not sure what that version you have is, maybe try the one found here? https://milviz.com/forum/viewtopic.php?f=107&t=9672

Sorry, no that product is very old. Did you try checking our old support forum?

Are you using a twist grip? There is a note in the docs folder: • The twist-grip throttle in the 530 incorporates a fuel cutoff as well as replicating enabling the governor when fully open. It also has an idle release function built in. Due to these included features, it is not currently recommended to bind the twist grip to a hardware controller. • Due to the replication of a proper turbine engine start-up procedure, using CTRL+E will not introduce fuel during the automatic start-up process. It is required to open the throttle manually to continue start-up, and to roll the throttle fully open to the governed position for flight. • The simulator currently only allows the engine governor increase / decrease function to be operated by key bind; the toggle switch on the pilot’s collective is inoperable. (The keybinds you want are ENGINE TRIM RPM INCREASE & ENGINE TRIM RPM DECREASE ) Also note: Skip the step in the before start checklist where it says Throttle FULL OPEN, GROUND IDLE, then CUTOFF. If you do that , it will cause a hot start. Start cranking the engine, do not add fuel until minimum 13%, I usually let it stabilize at 20% before adding fuel.

The flight model will be direct from P3D and adapted into MSFS - Since it is an external FM it should be 99% the same. The next answer is no, there is no external program that runs. Everything will happen within the confines of the sim.

Happy Friday everyone! Here is a peak inside our upcoming T6A ADV's cockpit! We're full steam ahead finalizing this bird, and can't wait for you guys to experience it