Search the Community
Showing results for tags 'sticky'.
Found 1 result
Many people complain about the bothersome detent in the pitch axis of this otherwise good product. There have been a number of "improvements" that others have done to counter this issue, such as removing one of the pitch springs, replacing them with other springs, or even one person who re-engineered the product to behave like the CH yoke with side springs which provide both pitch and roll resistance. Still others have cut the bushings and changed lubricants. After trying some of these suggestions, I still was not happy with the performance of this product. So today I decided to open it up for the 101 time. I thought that there must be some simple solution to this problem. I noticed that there are two plastic "horns" on the middle yoke shaft, and equidistant vertical tabs a few inches forward and back of it. This reminded me of a video of improving the CH yoke by attaching rubber bands to these horns. I decided to give rubber bands a try. Though I am not a fan of using rubber bands to fix issues, in this case the application is a good place to use them. I removed the two springs that control the pitch axis resistance and removed the arms to which they were attached to, saving them in case I wanted to go back to the original configuration. I found two identical rubber bands, rather thick and short, and attached one around the horns and front vertical tab, and the other around the horns and rear vertical tab. Finally I took a much smaller and thinner rubber band and simply strapped it across the two horns to secure the 2 main rubber bands upon strong deflection in the pitch axis. To my surprise, I did not need to do anything to secure the rubber bands about the vertical tabs, as the bottom cover of the yoke already has grooves into which these tabs slide into when you put the yoke back together. Its almost if Saitek designed the yoke with such a solution in mind. After putting it all together, its like a whole new yoke. Now I still have not had much time to test this out extensively, but the clunky mechanical detent is not there, and the yoke does return to center quite precisely, behaving more like the CH yoke. The resistance is uniform throughout the axis. Since I am only studying engineering , there may be improvements to this fix. Specifically, there may be a better way to secure the rubber bands from ever slipping off, though I don't think they will. Of course, more expensive rubber bands may help if these wear out. You may choose stronger/weaker rubber bands to suit your tastes. If you find the roll axis too stiff, you might want to remove the roll spring as well, though I find it to work well. The only drawback I have noticed thus far is that pitch resistance is very slightly higher when the yoke is turned, but this is barely noticeable and is just because the rubber bands must stretch more when you turn the yoke. It may also be possible to do this mod with springs instead of rubber bands, though that may be noisy. I may also make a cut on the plastic bushings, as there is still a tiny amount of stiffness when turning, but so far, I feel much more control in pitch. Please feel free to offer improvements. Tom G. Please note that this will void your warranty and I do not take any responsibility if you mess up your yoke. (Though its very unlikely). You may also have to recalibrate your yoke.