Archived

This topic is now archived and is closed to further replies.

Dondo

VoxATC X stopped initializing

Recommended Posts

Didn't change anything, and tried reinstalling VoxATC X and now when I 'Enable' Vox, I get the first few little dots after the "Initializing" and there it sits. I can use the Flight Plan trainer and I believe my Text 2 Speech functions in Vista are still working. Any suggestions?

Share this post


Link to post
Share on other sites
Help AVSIM continue to serve you!
Please donate today!

Your antivirus or software firewall may be interfering since Simconnect uses the TC/ICP. Make sure the indexer was allowed to run after re-installation or after any changes to airport facility information (AFCAD's), traffic programs, scenery or aircraft installations. You can check on the antivirus/firewall by disabling it when flying and see if VoxATC starts up normally. If it is the problem your antivirus may or may not have provisions for ignoring some programs. I am using NOD32 and had to set it to ignore anything using Simconnect to communicate with FSX.

Share this post


Link to post
Share on other sites