I just purchased FS2CREW for PMDG 737. DOwnloaded the PRO version since I have both PMDG versions. I installed it and installed service updates 1,2 and 3. I setup a cold and dark setup for KSFO so I can run the tutorial. I start MSFS and hit the C button on the panel and hit the green button to activate FS2CREW.I wait and a short time later the flight attendant knocks and enters asking about the briefing. The FA Brief Page flashes then disappears.Not sure if it is a bug or an operator error (i.e. me).Thanks for any assistance you can offerDave K

Ok, I just created the flight again and did not get a problem with the FA Brief Page. I guess it must have been the operator.Dave K

Hi Dave,Please take a look at the FAQ thread. Lots of helpful info there.Loading the PMDG 737 from the Cessna's 2D cockpit -and only the 2D cockpit- will ensure this doesn't happen again.Cheers,Bryan

Thanks for the info. After I recreated the flight I saved it. However, saving it does not seem to help. It looks like I have to actually go and create the flight each time via the Cessna, power off then switch aircraft. A bit cumbersome but not a show stopper.Thanks much,Dave K

Hi Dave,Yes, saved start files are generally speaking a no-go.Loading the cessna first and shutting it down as per the manual only takes a few extra seconds.It helps ensure everything get initialized properly.Cheers,Bryan