Spoiler Axis V1.2.2

[scott967 62]

Upgraded to 1.2.2. currently using FSUIPC to map an axis to spoiler. Should the same technique be used, set for prop pitch 1? that is, moving from 0 to half-range arms ground sopilers, set a null around the half-range area, and then the rest of the range is for flight spoilers?scott s..

[Bob Scott 7,745]

Yes, map the axis to PROP1, *not* to spoilers. As far as range goes, just set it up with a sufficiently large dead zone on the ends. You want the lever to stay at 0 when the handle is down...so give it a little extra room to drift around a bit.Arming the spoilers is done internally by the panel...when it sees the spoiler lever (actually the PROP1 axis) within the arming range for about a second, it arms the spoilers. The FSUIPC options to set an arming range for the spoilers actually serve to arm the FS9 autospoilers, which are deactivated in the FDE. The spoiler system in the TinMouse II is programmed independent of the FS9 autospoilers.RegardsBob ScottATP IMEL Gulfstream II-III-IV-V L-300Santiago de Chile