Hi all!Yesterday I bought both fs2crew for the LvlD767 and PMDG747.I must say that I realy enjoyed my flight with the 767, but the 747 was a bit of a dissapointment!The FO did not do some jobs he had to.For example.The FO should call descide just before landing, he didn't! I had to go around on my flight because of traffic on the runway so I did. I called go around and did my job to fly the aircraft over the runway and to our holding pattern.The FO did his job and did set flaps 20, raised the gear and that was all. My guess is that he jumped out of the plane from that moment and I never heard back from him.Nomather what I did, I was there by myself without any help.Should the FO handle even after a go around, or does FS2crew stops after it? I am curious because with FS, almost every flight I have atleast 1 go around because ATC just gives 2 planes clearence to be at the runways :(!ThanksStefan van Hierden

Hello Stafan,1. FO's "Decide" call... make sure set the correct DA/DH on the Approach briefing Page. The "Decide" call is definately there; my guess is that DA was probably set to an elevation below the runway itself.2. Go-Around's... You need to hit the Main Button to command the FO to raise Flaps 10, etc., just like you would during a normal climb out.The FO/PNF does not raise the flaps automatically; you have to command him.Cheers,Bryan

Thanks Bryan for the response!The problem was that the FO did not react after flaps 20. With both the main and secondary button I did not get any response. I will see if I can get it to work next time!About the DA, I did set 200 according to the charts (201) but maybe I misunderstood DA and DH. I am shure the fault is on my side :(!