I've run into a little snag that's probably staring me right in my face. I'm trying to set 2 buttons on my Saitek yoke to the 'autopilot select airspeed' on the default Learjet. The Learning Center says it should be "control+shift+R" as well as the Kneeboard.However,I sure can't find it in the Assignments page anywhere.That key sequence causes a problem with my keyboard,hence I would like to change them prior to adding to the yoke. Any help would be appreciated.Skip D

I am not sure this will help - but that assignment is probably in your FS9.cfg file - not on the assignments page.To see what I referring to, open your FS9.cfg (using notepad) and scroll down to the entry which says:AP_AIRSPEED_HOLD=82,10It should be under the (square braket)KEYBOARD_MAIN(square bracket) label. The 82 means R and the 10 means the Ctrl key is used.The only entry I see which has the R and the Ctrl + Shift is for AIRSPEED_BUG_SELECT=82,11In this case the 82 means R and the 11 is the Ctrl+Shift sequence.Info regarding the numbers etc. can be found in a document by Pete Dowson - look near the end of the document for the section named APPENDIX 1: List of Keyboard Codes.The filename here at Avsim is fs2000ctls.zip.Hopefully this will point you in the right direction.