Sign in to follow this  
Guest stefaandk

Crash when loading the pedestal in VC from saved flight.

Recommended Posts

Help AVSIM continue to serve you!
Please donate today!

I read your thread in the Level-D Forum... they beat you up a bit in there, hahaha :-)Is the 767 loading by default in the 2D cockpit? There is a switch in one of the FSX menus for this.The 767 needs to load by default so you start in the 2D cockpit. It sounds like you're saving a flight from the VC cockpit, which is a no can-do. Only save from the 2D cockpit.That's my initial guess.-Bryan

Share this post


Link to post
Share on other sites

I do load into the 2D cockpit but indeed did not "save" flights in the 2D cockpit as I don't actually use it apart from initial setup.So that rule obviously affects saves as well, I should then switch to 2D before saving.Didn't think about that at all. I'll try that and see if it solves it, will let you know.

Share this post


Link to post
Share on other sites

Yes so far so good.Saved at the same point twice, once in 2D, once in VC and reloaded. No crash on the 2D and crash on the VC.I better remember to not only start in 2D but also save my flights in 2D.Well glad to see this issue is resolves as it was driving me baddie.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this