Jump to content

Archived

This topic is now archived and is closed to further replies.

G7USL

Throttle Problem

Recommended Posts

I am using the saitek Pro Flight yoke with the extra three throttles. I also have them configured via FSUIPCWhe using the throttles in max power, engine number one closes in the sim after around ten seconds. It jumps back with movement of the lever.This doesen't happen at all in FSX.Anyone got any idea's of help please?

Share this post


Link to post
Share on other sites

Hi, Dave."I am using the saitek Pro Flight yoke with the extra three throttles. I also have them configured via FSUIPCWhe using the throttles in max power, engine number one closes in the sim after around ten seconds. It jumps back with movement of the lever.This doesen't happen at all in FSX."I think part of the reason you are not getting any feedback is the incomplete information you are posting?I am assuming you are using FSX with some after market acft, just as you use the FS9 with? I would recommend testing the set up in the Game Controller of your OS and see if you get the same behavior first, if not then try to see if you have another Axis assigned to that function, from another controller?Post more info with OS, Aircraft, assignments etc. for better feedback. TV

Share this post


Link to post
Share on other sites

Chuck your null zones via the in game settings as well. Make sure you have none for each axis.

Share this post


Link to post
Share on other sites

Thanks so much guys for replying.I think I have finally nailed it. I have changed the reverse thrust assignment from the obvious place, pressing the levers down into the red zone and by using just the 'F2' key only, the number one throttle doesen't change any more (I hope)?I had already closed the null zones, thanks.This hardware seem fraut with problems though :(

Share this post


Link to post
Share on other sites
Thanks so much guys for replying.I think I have finally nailed it. I have changed the reverse thrust assignment from the obvious place, pressing the levers down into the red zone and by using just the 'F2' key only, the number one throttle doesen't change any more (I hope)?I had already closed the null zones, thanks.This hardware seem fraut with problems though :(
Now its back again :(I'm running XPpro here.

Share this post


Link to post
Share on other sites

×
×
  • Create New...