I have borrowed a gauge from the default Beech_Baron.CAB. Other gauges I borrowed (gear_lever, aileron_trim, rudder_trim) work fine. I confirmed all image files exist.Why doesn't this gauge show up (where I have circled in red) ? As you can see the tooltip works (I tried moving the gauge around but no luck).<Gauge Name="Annunciator Gear Up" Version="1.0"><Element><Select><Value>(A:Gear left position,percent) 99 < (*gear is up*) (*AND*) (A:Trailing edge flaps0 left percent,percent) 90 > (*full flaps*) (*OR*) (A:Eng1 manifold pressure,inHg) 13 < (*AND*) (A:Eng2 manifold pressure,inHg) 13 < && || &&</Value><Failures><SYSTEM_ELECTRICAL_PANELS Action="0" /></Failures><Case Value="1"><Image Name="Annun_GearUp_on.bmp" Bright="Yes" /></Case></Select></Element><Mouse><Help ID="HELPID_GAUGE_ANNUNCIATOR_GEAR_UP" /></Mouse></Gauge>

check your BMP again. May be just a typo err. A missing dot etc.. Dietmar

Without a background bitmap -or- a bitmap that displays when <Case Value="0">, you won't see anything on screen!

<Case Value="0"><Image Name="Annun_GearUp_off.bmp" Bright="Yes" /><Case Value="1"><Image Name="Annun_GearUp_on.bmp" Bright="Yes" />

Thanks - makes sense - Since there was no base image, the base image must have been embedded in the Beech_Baron model. I did get it to work with case value = 0, as suggested, BUT in the education process I found the gear annunciator for the Gruman Goose and switched to that. Works nice...state of the art...