HI I sure would appreciate some help.I have just completed installing FS9 and all payware on a new computer. Do to all the payware having to be installed this took a few days. With all that done I think I have a problem or conflict with UTUSA and/or Ground Environment (installed GE last). I noticed when flying around areas it appears there is no autogen present at least as I remember on the old computer. Example: around KSEA. I no longer see any of the cranes and buildings from the airport in route to the city. Everything just looks flat but not blurry. However, if I disable UTUSA form the scenery library and restart, all of my buildings, cranes, ships etc. are present. When UT is enable all of the buildings etc.or no longer present I reinstalled UT but same problem. Should I reinstall GE after reinstalling UT or is there another problem? In the scenery library UT is shown below (high number) all my add on scenery. I did install all of the UT updates but no change when UT is enabled. Thanks for any help.Carl I7 860, 8 GB, ATI HD5770, W7

HI I sure would appreciate some help.I have just completed installing FS9 and all payware on a new computer. Do to all the payware having to be installed this took a few days. With all that done I think I have a problem or conflict with UTUSA and/or Ground Environment (installed GE last). I noticed when flying around areas it appears there is no autogen present at least as I remember on the old computer. Example: around KSEA. I no longer see any of the cranes and buildings from the airport in route to the city. Everything just looks flat but not blurry. However, if I disable UTUSA form the scenery library and restart, all of my buildings, cranes, ships etc. are present. When UT is enable all of the buildings etc.or no longer present I reinstalled UT but same problem. Should I reinstall GE after reinstalling UT or is there another problem? In the scenery library UT is shown below (high number) all my add on scenery. I did install all of the UT updates but no change when UT is enabled. Thanks for any help.Carl I7 860, 8 GB, ATI HD5770, W7

Update on my probably confusing request. I uninstalled UT. I did not remove GE from FS9. With GE installed I do have autogen and GE enviroment working. For some reason when UT is installed it disrupts GE and autogen. I sure hope there is an easy solultion. Thanks for any suggestions.

Have you checked this thread?http://www.simforums.com/forums/topic16313_page3.htmlscott s..

Have you checked this thread?http://www.simforums.com/forums/topic16313_page3.htmlscott s..

Have you checked this thread?http://www.simforums.com/forums/topic16313_page3.htmlscott s..

Scott,I can't thank you enough for sending me to this simforum thread, which was back in 2006. The problem is now fixed. I had been on thier forum but just didn't go back far enough to find the solution. I am getting to old for this kinda stuff but people like you and other on this forum are always ready to help us senior citizens.Carl