I've been a fan of FSNav 4.6 so when FS Com. 7.0 was announced I downloaded and installed the trial version and the patch. It appeared to have several features I would like to see in FSNav such as control zones and descent charts. However, I ran into a problem. I drive two monitors off the LeadTek Ti4600. When I drag FSC 7.0 to the second monitor and bring up FS2004 on the first, all is OK until I go to full screen (with Alt+Enter) on the first (FS2004) monitor. From then on, FSC 7.0 is locked out. All the menus are greyed out and clicking or moving the cursor anywhere on the second monitor which displays the FSC 7.0 window accomplishes nothing. FS Nav happily doesn't exhibit this flaw or am I doing something wrong?I suppose you could run FSC 7.0 on a second computer connected to FS2004 via WideFS?Larry JonesFlorence, MT

Larry,you certainly have come a couple of steps further than I have! :)I'm totally new to Flightsim Commander and haven't got a clue how to get the program plugged in to MSFS so to speak. I have a registered FSUIPC version but really don't know how to continue and the manual doesn't mention this with a single word (or have I missed something ... again).If you can help me getting started I'll gladly share my results as to your question!Edited: Found that Local mode button. This is quite different from fsnav!Best regards,Krister Lind

its a shame that the author wont respond to support questions, i know i also had a question regarding certain features with this program...and the author STILL hasnt replied at all (after 3 emails spanning 2 weeks)...its obvious he's around too (just launched his new website and all).The program has good potential as a planner, but i refuse to give someone any of my money after being ignored time after time for support.Dave