Good evening everyone,Im having a little issue with fsuipc's axis assignment and was wondering if anyone has run into the same problem. I am also going to try and explain it as best as I can as this is the only obstacle keeping me from flying my sim at the moment and would like to get it solved, so here goes:a little info, Im using saitek throttle control, and trying to use it with the IFly 737.I am trying to get throtle 1 to be used with engine 1, and throttle 2 to be used for engine 2.I can get the 2 throttle controles to control the throttles in the sim, but the problem is when i add throttle say 25% for example, the sims throttle goes to 25% but after about 3 - 5 seconds of not moving the axis on the saitek controld the throttles on the sim go back to idle alone. If I put the throttles to any setting be it 25% 50% 65% 100% etc etc after about 3 to 5 seconds the throttles in the sim go back to idle. Anyone run into this before?Thanks in advance.

Hi,I think you would get the best response at the FSUIPC forum, here: http://forum.simflight.com/forum/30-fsuipc-support-pete-dowson-modules/Hugo