The V1.31 update is now available

[toelg 1]

I'd like to hear back from the people that were having problems with disappearing/nonfunctioning airspeed needles etc to know if this update has solved that problem.

Hi Bob,thanks for the new 1.31 update ! Now the needle works well, but it is necessary to load a default FSX-aircraft, else there is no airspeed indication.By the way, the clickspot-area for AES was a great idea ! :( Best wishes for the New Year ! Dietmar

[Bob Scott 7,728]

Hi Bob,thanks for the new 1.31 update ! Now the needle works well, but it is necessary to load a default FSX-aircraft, else there is no airspeed indication.By the way, the clickspot-area for AES was a great idea ! :( Best wishes for the New Year ! Dietmar

OK, well at least it works now. One thing does come to mind...make sure your default flight opens in the 2D cockpit...if FSX first initializes in the VC (or an exterior view), it can unleash a number of odd gremlins.RegardsBob ScottColonel, USAF (ret)ATP IMEL Gulfstream II-III-IV-VColorado Springs, CO

[TrevorS 54]

I have sent an e-mail to the support address.RegardsTrevor

[Airbusman 1]

Autobrakes are not working for landing but RTO works fine. When its time to select it for landing the inop light stays on and no brakes were available during landing. Other than that the plane performed flawlessly.

[Bob Scott 7,728]

Autobrakes are not working for landing but RTO works fine. When its time to select it for landing the inop light stays on and no brakes were available during landing. Other than that the plane performed flawlessly.

That's usually caused by a hardware axis that's spiking or not calibrated to a zero value when the brakes are not being applied.RegardsBob ScottColonel, USAF (ret)ATP IMEL Gulfstream II-III-IV-VColorado Springs, CO

[TrevorS 54]

Hi BobThanks for the patch. All working fine now - no skips and no "doubles".It even holds the mach speeds correctly now.What was the problem? Your hunch was obviously correct.ThanksTrevor

[Bob Scott 7,728]

Hi BobThanks for the patch. All working fine now - no skips and no "doubles".It even holds the mach speeds correctly now.What was the problem? Your hunch was obviously correct.ThanksTrevor

I'm curious what kind of CPU you are running there. This may be a CPU-dependent issue that has to do with how floating-point ops are handled, specifically how rounding is done. Anyway, I did some explicit rounding in the routine that displays the individual digits on the MCP.RegardsBob ScottColonel, USAF (ret)ATP IMEL Gulfstream II-III-IV-VColorado Springs, CO

[TrevorS 54]

CPU is an Intel E7400 Core 2 Duo @ 2.8 GHz.Trevor